Chemical anchoring systems are used within the building and construction industry for a wide range of applications. These resin-based systems can be used to fix a variety of components and fixtures directly to a substrate. Each system has been designed to meet the high performance standards of the construction industry and is manufactured within the internationally recognised ISO 9001:2000 Quality System.

Our resins have been tested by several renowned international institutions

Main Applications

• Structural connections transferring high loads into slim columns
• Fixing sanitary-ware to hollow masonry
• Holding down bolts for steel columns
• Tying back existing masonry facades to new steel structures
• Dynamic applications: holding down machinery
• Fixing starter-bars for reinforcements
• Wall-tie replacements

• Reliability - Accurate 'self-mixing' system for guaranteed quality.
• Strength - The cured resin is stronger than the main substrate.
• Convenience - Our systems avoid the problems encountered with traditional 'on-site' mixing.
• Resistance - Our systems result in high chemical and vibration resistance of the anchor and resin.
• Economical - The fast-curing nature of our systems minimises expensive on-site delays.
• Versatility - Our systems can be used for horizontal, vertical and over-head applications.
• Long-life - All the cartridges are re-sealable minimising waste.
• Close-edge fixings - Our resin systems put minimal stress on the main substrate allowing anchors to be placed in areas where mechanical systems would cause cracking and failure of the main substrate.
• Underwater use - Our resins provide excellent results in underwater applications.

Formulations
Chemfix chemical anchoring systems are supplied in formulations designed to meet specific applications including: Epoxy Acrylate/Vinylester, Polyester and Pure Epoxy, Styrene-free (Epoxy Acrylate, Polyester) or special Tropical Grade and Arctic variants are also available.

(For technical data on all our resins please follow the following link - Technical Data)

Cartridge Sizes
150ml Valveless Coaxial 10:1
150ml/170ml Valveless 10:1 (for use with silicon gun)
300ml Valveless 10:1 (for use with silicon gun)
330ml/345ml Valveless Parallel 10:1
380ml/400ml Valveless Coaxial 10 :1
380ml/400ml Valved Coaxial 10:1
400ml Valveless Parallel 1:1
825ml Valveless Parallel 10:1

385ml Valveless Parallel 3:1