| Epoxy Brick Adhesive |
|
Epoxy Brick Adhesive 1:1 is a solvent free thixotropic two part general purpose building adhesive. Once mixed Epoxy Brick Adhesive forms a powerful structural adhesive offering high chemical resistance. Site application is improved due to its damp tolerant nature and ability to through cure at relatively low temperatures down to 5oC.
OUTSTANDING FEATURES
- Easy mixing ratio, 1:1 by weight or volume
- Thixotropic can be used on vertical and horizontal surfaces
- Excellent chemical resistance
- Very good mechanical properties
- Good colour stability
- Excellent adhesion even in damp conditions
- Can be used to bond virtually all building materials, including glass, wood, concrete, metals etc
- Supplied unpigmented to allow for easier colouring
- Excellent low temperature performance
Preparation
Prior to application all substrates must be sound, clean and free from surface water.
Smooth or coated surfaces should be abraded or scored before bonding.
Application
Mix the base and an activator component thoroughly together until an even colour and consistency is achieved. Mixing is best carried out on a smooth clean board using a wide bladed scraper. Apply by trowel, spatula or scraper with a minimum thickness of 1mm. On damp surfaces work the Epoxy Brick Adhesive well into the substrate and ensure bonding takes place while the adhesive is still mobile and tacky. The components should be supported during curing to eliminate potential slippage.
|
|
|
Technical Data
MIXING RATIO 1:1 BY WEIGHT OR VOLUME
GEL TIME (100 GRMS AT 20OC) 50 MINS
CURE TIME 24 HOURS
COVERAGE (AT 1mm THICKNESS) 0.6m2
APPLICATION TEMPERATURE 5 - 30 oC
COMPRESSIVE STRENGTH
(ASTM D695) 58 N/mm2
TENSILE STRENGTH (ASTM D638) 19 N/mm2
FLEXURAL STRENGTH
(ASTM D790) 42 N/mm2
ELASTIC MODULUS 7496 N/mm2
FLEXURAL MODULUS 4826 N/mm2
SHRINKAGE NEGLIGIBLE
CLEANING CLEAN ALL TOOLS WITH METOCLENS. CURED MATERIAL CAN ONLY BE REMOVED MECHANICALLY.
SHELF LIFE 18 MONTHS FROM DATE OF MANUFACTURE.
Health and Safety
Epoxy Brick Adhesive is classified as an irritant, corrosive and may cause sensitisation on repeated skin contact. Wear suitable protective clothing such as gloves and overalls. On contact with skin wash off immediately with plenty of soap and water. If any irritation persists or a rash appears seek medical advice. For further information refer to the Material Safety Data Sheets.
Important
The information and data given is based on our own experience, research and testing and is believed to be reliable and accurate. However, as Nickerson Chemicals Limited cannot know the varied uses to which its products may be applied, or the methods of application used, no warranty as to the fitness or suitability of its products is given or implied. It is the users responsibility to determine suitability of use. For further information please contact our Technical Department.
APPROVED
|
|
|
|
